Mounting the stand
1.
Site preparation
Place the bike on a flat surface and make sure you have enough room to handle it. You'll need a size 15 spanner wrench (included).
2.
Removing the plastic cap
Remove the plastic cap on the nut on the left side of the rear wheel.
3.
Release of the nut
Counterclockwise release the nut holding the wheel.
4.
Removing the washer
Remove the washer from the rear axle of the bicycle.
5.
Stand in place
Attach the stand to its place on the left side of the bike.
6.
Tightening the stand
Place the washer on the axle and screw the nut back on. Check that the wheel is seated straight so that the brakes do not scrape the rim and tighten the screw. Once the stand is fitted, check that the rear brake is working correctly and that the wheel can be turned.
7.
Putting on the plastic cap
Put the paste cap back on the nut.
8.
Stability control
Make sure the stand holds the bike steady and secure.
